Dan Dugan Sound Design E Guide de l'utilisateur Page 18

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 62
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 17
Dugan Model E-3 User Guide
18
ADAT
Move the AES–ADAT switch to the ADAT (down) position. This switches the I/O to the
ADAT connectors. Word clock is available on the upper DB25 connector.
The state of the
8–16 Ch switch determines the I/O count and linking capability. This
can be set in the Dugan Control Panel (see Chapter 4: Dugan Control Panel)orwitha
power-up command (see Appendix A: Power-up Commands).
8-Ch
Channels 1–8 on AUD IN/AUD OUT.
Linking and the Music System are available
Music System threshold inputs are in AES format on the upper DB25 connector
16-Ch
Channels 1–8 on AUD IN/AUD OUT
Channels 9–16 on LINK IN/LINK OUT
Neither the Dugan Music System nor linking are supported
Music System Threshold Inputs
A Music System threshold signal can be provided as a reference for each group. When
the levels of channels in the group exceed the level of the Music System threshold
signal, the channels come up to full gain.
The sensing mics can be patched to the same console as the program mics, but are
typically routed to sends or direct outputs, not mix busses.
On the Model E-3, up to three AES audio signals can be received on the auxiliary
DB25 connector as Music System threshold inputs (
MSTIN13), one for each group
(a, b, c). On a DB25-to-XLR AES/EBU breakout snake, the Music System threshold in-
puts are on the female XLRs labeled 1-2 and 3-4 (use left channel only).
Word Clock
The Model E-3 receives external word clock on the auxiliary DB25 connector
(pin 7 = signal; pin 8 = ground). On a DB25-to-XLR AES/EBU breakout snake, the
word clock input is on the female XLR labeled 7-8 (pin 2 = signal, pin 1 = ground).
The Model E-3 outputs word clock on the auxiliary DB25 connector (pin 1 = signal;
pin 2 = ground). If you use a DB25-to-XLR AES/EBU breakout snake, the word clock
output will be on the male XLR labeled 7-8 (pin 2 = signal, pin 1 = ground).
Vue de la page 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 61 62

Commentaires sur ces manuels

Pas de commentaire