Dan Dugan Sound Design E Guide de l'utilisateur télécharger pdf (Page 11)

Dugan Model E-3 User Guide

Chapter 2: Quickstart

This section provides step-by-step instructions to help you get started quickly using

the Dugan Speech System to mix up to eight channels. Fourteen- and sixteen-chan-

nel I/O is available using the Dugan Control Panel software. See Chapter 5: Dugan

Control Panel to learn about these options.

Typical Setup

1. Connect the provided power supply to the Model E-3.

2. Hold the channel 1 bypass button down and power up the unit. Keep holding the

bypass button down for three seconds until the unit finishes booting.

This System Reset command sets all parameters to factory default settings and

clears label text.

We recommend executing a System Reset before starting a new installation. This

is just like zeroing a console before a show.

3. Set the NORM-SLAVE switch on the rear panel to NORM (up) for unlinked operation.

The Model E-3 can be interfaced using AES or ADAT connections:

4. AES: Move the I/O switch on the rear panel to the AES (up) position.

The lower DB25 connector (wired with the Tascam convention) is used for dig-

ital I/O.

Since digital mixers use a variety of I/O connectors, you must obtain a DB25 dig-

ital breakout adapter cable to connect to the console.

Figure 2-1 Model E-3 rear panel

ADAT: Move the I/O switch on the rear panel to the ADAT (down) position, con-

nect the console ADAT output to AUD IN, and connect AUD OUT to the console’s

ADAT input.

5. In the console’s internal patching system, route each Model E-3 channel as a post-

fader, pre-compressor insert to each mic channel (see figure below).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 61 62

Pas de commentaire

Dan Dugan Sound Design E Guide de l'utilisateur Page 11