Dan-dugan-sound-design E Manuel d'utilisateur télécharger pdf (Page 15)

Dugan Model E User Guide Installation

Insert

This is the normal way to connect the Model E using a mic-level signal. Patch the audio

channels in the insert loop (send-return) of each console input strip. Check the insert

jack wiring on your mixing board. If they are 1/4-in TRS jacks (wired tip = send, ring

= return), use TRS-TRS insert cables to connect the Model E. Other configurations re-

quire special cables. The Model E is wired as follows: tip = input, ring = output.

Figure 3-3 Analog insert (left) and line level (right) block diagrams

Line Level

This is an optional method of connecting the Model E to line-level devices, such as wire-

less mic receivers. Use split insert cables. The receiver output is wired to the tip of the

TRS plug. The connector for the mixer’s line input is fed from the TRS plug’s ring.

3.2.2 Digital I/O

Start up the Model E in Digital I/O mode by holding down the channel 3 bypass button.

This switches all I/O to the ADAT link connectors. Linking is not possible and the an-

alog connectors are inoperative.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Pas de commentaire

Dan-dugan-sound-design E Manuel d'utilisateur Page 15