Dan-dugan-sound-design E Manuel d'utilisateur télécharger pdf (Page 17)

Dugan Model E User Guide Installation

3.3.2 Digital

Adjust the console input gain trimmers so that talking signal levels at the sends are

between -20 and 0 dBFS, and room noise at the sends is higher than -75 dBFS. Console

input gains should be high enough so the level lights stay green all the time, but do not

turn red on peaks.

3.4 Power-up Commands

The Model E can execute one of six commands during each power-up. Select the com-

mand by holding down a specific button during the entire power-up process. Power-up

is complete after the bypass LEDs light sequentially and extinguish.

System Reset

Hold the channel 1 bypass button down to set all parameters to factory default settings,

clear label text, and set the I/O to analog. We recommend starting an installation in this

mode.

Network Reset

Hold the channel 1 mute button down to set these parameters to their default values:

IP: 192.168.0.1

Netmask: 255.255.255.0

DNS: 192.168.0.254

Gateway: 192.168.0.254

DHCP:off

DHCP On

Turning DHCP on requests that the network assign an IP number to the Model E, if the

network has that capability. To turn DHCP on, hold the channel 2 bypass button down.

Display IP Address

Hold the channel 2

mute button down to display the address for 30 seconds. The bottom

four LEDs of each bargraph represent one digit in hexadecimal format.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Pas de commentaire

Dan-dugan-sound-design E Manuel d'utilisateur Page 17