Dan-dugan-sound-design E-1 Manuel d'utilisateur télécharger pdf (Page 11)

Dugan Models E-1 and E-1A User Guide

Chapter 2: Quickstart

This section provides step-by-step instructions to help you get started quickly. It in-

cludes information to connect and install the Model E-1A, make initial settings, and

link units.

Connections

1. Connect the provided power supply to the Model E-1A.

2. Set the NORM-SLAVE switch on the rear panel to NORM (up) for normal (not linked)

operation.

The Model E-1A can be interfaced with an analog or digital console using analog

or digital connections.

Analog I/O

1. Move the I/O switch on the rear panel to the ANALOG (up) position.

The Model E-1A is a line-level device normally patched into the insert jacks (send

and return) for each mic input channel on the board.

2. Check the insert jack wiring on your console.

If they are 1/4-in TRS jacks (wired tip = send, ring = return), use TRS-TRS insert ca-

bles to connect the Model E-1A. Other configurations require special cables. The

Model E-1A is wired as follows: tip = input, ring = output.

Figure 2-1 Analog connection

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Pas de commentaire

Dan-dugan-sound-design E-1 Manuel d'utilisateur Page 11